• The Laminar Air Flow Booth and the Control booth both have flat, smooth surface for the ease in cleaning ​and the prevention of germs and contaminants.
  

• Come with anti-static transparent plastic strip curtains
  

• The air circulation within the Laminar Air Flow Booth have fan with the specifications as listed below.
  

1. Has supply fan installed on top of the HEPA filter sheet, and also come with HEPA filter altogether.
2. The supply fan is an EC motor of a Centrifugal fan type, which is controlled by the controller, to ​automatically compensate the wind speed within the working area of the Laminar Air Flow Booth to ​remain in the range of 0.36 – 0.54 m/sec, in the case where the blockage of HEPA filter or the ​turbulent air flow occurs eventually after the usages of the Laminar Air Flow Booth.
   
3. The supply fan is designed by prioritizes the maximum efficiency of the HEPA filter operation. The ​supply fan must also be designed to generate at least 1,200 m³/hr. of volumetric flow rate of air, in ​order to overcome the system’s static pressure of at least 145 to 680 Pa, as referred to the product ​specifications of the supply fan used in the design process.
   

• The Control booth includes the controller of Laminar Air Flow Booth with the following features:.

1. An adjusting button to adjust or configure the setup of the operation, and monitor screen to display the clear results of the operation setting when the Laminar ​Air Flow Booth is adjusted or configured. For the convenience of the users to change the setup of the operations to suit their working processes.
2. A limited access to adjustment and configuration of the Laminar Air Flow Booth.
   
3. Import-export data portal of RS485 type and LAN Ethernet type on the controller, for the stability during the data import and export processes.
   
4. Support the data import-export to the Building Automation System (BAS) of Modbus Protocol type, with the important parameters for data recording (21 CFR ​Part 11) as followed;
   

- Pressure drop of the HEPA filte

- Operation status of the fan and the percentage of the fan operation

• A portal for the release of testing substance and a portal for concentration checking of the ​released testing substance with regard to the HEPA filter Leakage Test by not releasing the ​testing substance afterwards
  

• support the electrical system of 220 – 240 V at the frequency of 50 Hz.
  

• Operate smoothly as usual after a power shortage or power outage occur, with the ​configured parameters remain unchanged.
  

• There is a lighting system that can supply not less than 500 Lux within the Laminar Air ​Flow Booth. The workspace is equipped with a lighting system that provides appropriate ​and sufficient illumination for operations.

• The operation of the Laminar Air Flow Booth not cause more than 85 dB of noise.
  

• The Laminar Air Flow Booth is properly installed inside the Micro Limit Test room and able ​to function accordingly to the desired tasks
  

• The Control booth installed in the Micro Limit Test room to allow the users to have a clear ​vision of the alerts or notifications of abnormal operation at the front of Booth. The ​abnormalities include the disfunction of fan and the blockage of the HEPA filter sheet ​status.
• The design, manufacture, installation, and qualification must be done accordingly to the ​Notification of the Ministry of Public Health RE: Determination of specifications in ​regulations of modern medicine manufacture and adjusting the criterion and methodology ​used in traditional medicine manufacture, issued under the Drugs Law, B. E. 2559 or ​ISO14644-1, ISO14644-3, ISPE or other associated standards.